X10 Community Forum
📸Cameras & Camera Software => Camera General Discussion => Topic started by: dr_bob on September 13, 2006, 02:22:25 PM
-
I have recently upgraded from the original Active Home with a serial interface to Active Home Pro with its USB interface. Since this installation, I have noticed that my floodcam turns on when it senses motion but does not automatically turn off. Has anybody else had this problem and, of course, anyone have a solution?
I have a second question: Is it possible to pick up a signal in Active Home Pro when the floodcam turns on?
Thanks
Dr_Bob
-
Dr. Bob,
I have very similar issues with my FloodCams. I usually end up having to use the turn all units off function or try and flip through cameras to force it off. I have tried the FloodCams in Manual and Auto mode with no real luck. If there is a good solution, I would love to hear about it! I was hoping that the manual mode would keep the camera off even if there was motion, but one can only hope. I may just swap the floodcams for motion sensed floodlights from one of the local retailers to avoid this headache. I believe they would work well if all you had were floodcams since the floodcam sends an off signal to the other three in the group of four configuration.
-
How did it work out, Dr Bob?
I assume you went to your local home store. Probably a good choice...
-
Hello
I, too, am finding the identical problem. USB active home pro intermittantly triggering the floodcams.
-
I have never owned the FloodCam. Where I already had floodlights wasn't a good place for cameras.
However, I do own the X10 dual floodlight (PR511). They're great. I use mine to trigger X10 cameras, inside lights, a chime, and a macro in AHP that triggers the VCR commander ON.