X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wireless Cameras(non IP) => Topic started by: funkpelts on October 15, 2006, 10:42:56 PM
-
I can't get my vanguard software to show my camera. It shows the correct code for it A1 but shows no pic and acts as if it is scanning for a cam. When I start the vanguard software, it says it does not detect the va11 adaptor, but I have plugged and replugged it in and restarted a couple times to see if it just needed refreshed. The cam works fine if I just plug the receiver to my t.v.
Anybody have this problem? What should I try and is the va11 most likely defective?
-
Do you have the VA11A software driver loaded into your computer? If so, try removing it and re-install it.
Robert
-
Another thought. When I first loaded my VA11A driver software I had Active Home running -- the VA11A did not work until I shut down Active Home and restarted it.
Robert