X10 Community Forum

🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: nimbleslick on December 04, 2006, 01:11:15 AM

Title: Motion Sensor Macro Problems
Post by: nimbleslick on December 04, 2006, 01:11:15 AM
My problem sounds simple, but I am having a devil of a time resolving it. The set up is simple - I have two nightstand lamps in my bedroom, both assigned as A2. Near the entry way, I have an Eagle Eye Sensor set to A1.

The set up works fine when the motion sensor triggers the lamps. However, I don't always want this to happen. I have tried creating several variations where motion sensor cannot trigger the lights after 1AM, but each time the lights simply flash on and off. Any suggestions? Thanks!

B
Title: Re: Motion Sensor Macro Problems
Post by: Charles Sullivan on December 04, 2006, 01:23:10 AM
My problem sounds simple, but I am having a devil of a time resolving it. The set up is simple - I have two nightstand lamps in my bedroom, both assigned as A2. Near the entry way, I have an Eagle Eye Sensor set to A1.

The set up works fine when the motion sensor triggers the lamps. However, I don't always want this to happen. I have tried creating several variations where motion sensor cannot trigger the lights after 1AM, but each time the lights simply flash on and off. Any suggestions? Thanks!

For one thing, the motion sensor will be sending another signal on A1+1 (i.e., A2) from its light sensor.  Change your lamps to A3 and start over.