X10 Community Forum
💬General Category => General Discussion => Topic started by: ttfd1126 on January 16, 2007, 08:57:48 PM
-
I have had my X10 for quite some time and I thought I was getting pretty good at it. I have one obnoxious light with WS467 swtich that when turned on is blinding. I can dim it via the AHP software, but is there a way to make it start up at a predetermined brightness at the switch each time it is turned on?
-
I have had my X10 for quite some time and I thought I was getting pretty good at it. I have one obnoxious light with WS467 swtich that when turned on is blinding. I can dim it via the AHP software, but is there a way to make it start up at a predetermined brightness at the switch each time it is turned on?
Not with the WS467. This switch is only a listener... you would need a switch that repeats it's X10 address as a PLC command when pressed manually, so that AHP can use it and trigger a macro to auto dim itself. (See ICON dimmer switches as an example).
-
Some of the other brand wall switches can be set to a preset on level; also ramp up and down slowly and can send a X10 signal back on the power line when locally toggled.. Just read the switches specifications. Many including the Icons also need a neutral power wire in the switch box. The WS467 steals power through the light is is controlling and doesn't need the neutral wire.
-
Thanks for the quick replies. I guess I will change out this switch for a different brand.
-
Actually, you don't need a switch that transmits its address to do this. The Leviton discontinued "red line" and their newer "green line" X10 switches will do exactly what you want. They remember the last dimmer setting, and ramp up to that when turned on. They can also be sent a pre-set dim command so they will turn on at whatever brightness level you want. Their older "red line" switches have worked flawlessly for us since we built this house. They do require a neutral though.
Jeff