X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: anhnn100 on August 21, 2007, 11:39:51 AM
-
I can control ws12a, but dont know why cannot control sw13a ans xps3. Both of them are using for fluorescent. The sw13a connect to ws14a for 3-way light. Does the software work for them?
-
Are you using Active Home or Active Home Professional? If Active Home and the CM11A serial interface, the correct forum is the one dealing with Active Home.
-
I am using Active Home Professional.
-
Were are the WS12As in relation to the WS13A/WS14A installation? You may have a signal problem to the area where the WS13A/WS14A unit are installed. If you set them all [as a test] to the same address can you then turn them on; with an ON command; to the common address?
The WS13A/WS14A switches do work manually?
-
I used to use remote control to turn lights on/off. It work find with remote or manual. I just cannot control by the activeHomePro software with the sw13a and sps3. The software just turn it off, but not on.