X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: whsbuss on September 05, 2007, 05:58:43 PM
-
I have AHP w/CM15A. When I use the remote to send commands the activity monitor shows multiple receives of the command. It causes problems with downloaded macros (I don't keep my PC connected to the CM15a). No matter what flags are set when the macro is run from the rf remote I get both branches of the IF/ELSE. Running the macro from the PC works fine.
Any ideas?
-
Can you post your macros? Either screen captures or the typed out version.
-
Also post what other X10 Hardware you have installed (repeaters,transceivers)! ???
The most common problem is additional transceivers not configured properly in AHP! ;) :D ;D
-
Well I solved the extra RF signals by placing 3 second delays at the beginning and end of eah macro that is called by the remote. I have nothing but the CM15A - no repeaters, etc.