X10 Community Forum

📸Cameras & Camera Software => Camera General Discussion => Topic started by: nobleskydiver on October 12, 2007, 12:34:02 AM

Title: Mutiple TM751 on same house circuit code
Post by: nobleskydiver on October 12, 2007, 12:34:02 AM

Dear experts,  Do you need to use the TM751 for each set of 4 in a group?  or is one enough? 

Is the clicking noise heard from within TM751  normal switching on/off

Title: Re: Mutiple TM751 on same house circuit code
Post by: Charles Sullivan on October 12, 2007, 07:39:32 AM

Quote from: nobleskydiver on October 12, 2007, 12:34:02 AM

Dear experts,  Do you need to use the TM751 for each set of 4 in a group?  or is one enough? 

Is the clicking noise heard from within TM751  normal switching on/off

The TM751 transceives RF signals for all 16 unit codes in the housecode.  You'll need only one per housecode.

The clicking noise is the relay for the built-in appliance module.  It only responds to On/Off RF signals with unit code 1.  Except for the audible annoyance, it can be ignored if you have nothing plugged in.

 

Title: Re: Mutiple TM751 on same house circuit code
Post by: Brian H on October 12, 2007, 06:05:07 PM

It also does not have a powerline receiver in it. So it can not be controlled by a powerline controller. Like a Max-Controller etc.