X10 Community Forum

📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => XRay Vision => Topic started by: Grutozoid on October 18, 2007, 05:46:10 PM

Title: Error8007001f: Cannot run preview graph...
Post by: Grutozoid on October 18, 2007, 05:46:10 PM

I dont used Xray for months, using a direct surveillance monitor...

Now my monitor is dead... I would like to see my images on PC...

I have Xray program, VA11A, CM19A, 3 cams and VR36A receiver.

I installed Xray which calls for drivers install and everything went well.

I rebooted, connect VA11A, start Xray and I get that message... :o

Any ideas? ???

I done driver update as seen on forum but I have 3 drivers available, CA506A, AA and AV.

Which one is best? :'(

Thank's!

Louis.

Title: Re: Error8007001f: Cannot run preview graph...
Post by: Tuicemen on October 18, 2007, 07:30:23 PM

Your problem is most likely the wrong driver for the VA11A has been installed(Windows installs Intel cam driver if you do an automatic driver install)!
try this fix  VA11A does not work    (http://www.x10community.com/forums/index.php?topic=8083.msg49642#msg49642)
If your using Vista you will most likely have to do this VA11A won't work in Vista (http://www.x10community.com/forums/index.php?topic=13179.msg68678#msg68678) as well! ;)