X10 Community Forum
🖥️ActiveHome Pro => SDK => Topic started by: RMI on January 15, 2008, 08:41:57 PM
-
Hi All,
I have a CM19E Transceiver Module. I've imported "X10Net.DLL" into my C# application (exposing the "X10" Namespace), and using the "_DIX10InterfaceEvents_X10CommandEventHandler" routine I can receive and process data from the Transceiver. However, I'm struggling to find a way to Send commands (Address On, Address Off, Address Bright, Address Dim etc) using the same DLL.
I've contacted X10 Support - unfortunately their reply was "I am afraid we do not provide any support information for that DLL." :(
Can anyone help me out here?
Any clues/hints/pointers/code samples - anything - would be *very* much appreciated!! :)
Thanks in anticipation,
Rob
-
Get the SDK (http://www.x10.com/activehomepro/sdk/index.html) for ActiveHomePro (CM15A) it also works with the CM19A so it should work with the CM19E.
The SDK aids in communicating with the X10Net.dll
-
Hi,
Thanks for that. I did look at the SDK previously (briefly) - but I wasn't sure if I had to run ActiveHome software in order to make use of the SDK - can you clarify this for me?
Kind regards,
Rob
-
The SDK includes Redistributable components so AHP doesn't need to be loaded(installed) or if you have it installed it doesn't need to be running! ;)
At least they use to be with it! ::) ???
If they aren't included you can find them here: SDK Redistributable components (http://x10dispatcher.com/Downloads.aspx)
-
Fantastic!
Thanks for the prompt and helpful reply. :)
Rob
-
Glade you found it helpful, and didn't give me a negative rating! ;) ;) ;)
Welcome Aboard!
Let us know how you make out!
Most members here are from North America but there are others that may benifit from your experiance! ;)