X10 Community Forum
🖥️ActiveHome Pro => Plug-ins => OnAlert => Topic started by: Charles Sullivan on January 23, 2008, 11:42:10 PM
-
Can anyone owning an MS10A Security Motion Sensor and having AHP with the OnAlert plugin let me know whether their MS10A behaves the same as mine, i.e.:
When motion is detected, the sensor transmits the Alert signal. Then 10 seconds later it transmits the Normal signal, regardless of whether or not there is continuing motion. After a refractory period of around 1 minute (and assuming continuing motion), it will again transmit the same Alert - 10 seconds - Normal sequence.
(This seems strange, and differs from X-10 non-security motion sensors, which don't transmit a Normal signal until some interval after the motion stops.)
Thanks for your response.
-
I don't use mine anymore but I do recall the same fixed delay followed by the normal signal regardless of continuous motion.
-
I don't use mine anymore but I do recall the same fixed delay followed by the normal signal regardless of continuous motion.
Thanks Puck.
[Edited]
And thank you too Tuicemen.
-
Charles Sullivan Mine operate/display as yours do! ::)