X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wireless Cameras(non IP) => Topic started by: JLudwig on June 24, 2008, 09:33:31 AM
-
Hi , I was hoping someone could give me some help.
3 floodcams, 1 mounted 1 temp mounted, ( 1 still in box) I have the cams set to manual, the issue is when I reboot the system, the cams operate fine ....walk in front of 1, picks up motion, can see video, walk in front of cam 2 , changes to cam 2, can see video, works great. when I use the scan cam remote, I can see video, press 2 can see 2, press 3 can see 3. now heres where it gets a bit odd.....after using remote....it won't go back into auto mode, unless I power off then back on cams, if I walk in front cam 2 .....it will go to blank screen.......walk in front of cam 3....same, blank....seems like no video input, seems like it is not turning cam on and off properly
cams set to A-2 and A-3
Cam channel set to A
scancam remote set to A
tm751 set to A
Ideas?
Thanks in advance