X10 Community Forum

🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: bennybronz on July 02, 2008, 01:25:31 AM

Title: Macro not working on interface but working on computer
Post by: bennybronz on July 02, 2008, 01:25:31 AM

I have just a simple marco the has a eagle eye sensor that triggers 3 dimmable switch modules. The macro is set to turn on the lights not dim them. When I click on the marco on the computer it runs fine.  When I wave my hand in front on the sensor the marco triggers but nothing happens even though the switchs show they have turned on on the computer.  When I look at the activity monitor it shows that the marco just triggers to dim 100% even though i have them set to absolute on?? if I set the marco to turn all lights on then it works. Once again if i click the marco on the computer it works fine and the activty montior shows the modules coming on rather than the dim 100% like when its triggered off the interface.

Please help

Thanks

Title: Re: Macro not working on interface but working on computer
Post by: HA Dave on July 02, 2008, 02:17:13 AM

The quick and simple fix: Try re-writting the macro so the the motion sensor triggers a simple On/Off appliance module (fake) instead of the switches. Of course... use the same House/unit codes.