X10 Community Forum

🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: thejfk on October 06, 2008, 10:12:01 AM

Title: Macros set up
Post by: thejfk on October 06, 2008, 10:12:01 AM
OK,so I am trying to set up a hallway and bathroom light macros.
Here's what I want:

All macros triggered by eagle eye motion sensor (D1)
6:00pm-11:00pm hallway light (A12) comes on 99%
11:00pm-5:00am A12 comes on 50%
5:00am-6:00am A12 and A9 (bathroom light) come on 99%
6:00am-7:00am A12 comes on 99%

I created 4 macros (by using elses)

1:trigger D1, conditions between 600:pm and11:00pm...A12 99% on...delay,...A12 off
2:trigger D1, conditions,between 11:00pm and 5:00am...A12 on 50%...delay...A12 off
3:trigger D1,conditions,between 5:00am and6:00am...A12 on 99%,A9 on 99%...delay...A12,A9 off
4:trigger D1,conditions,between 6:00am and 7:00am...A12 on 99%...delay...A12 off

I tested it, Macro 1 worked, the others didn't.

The manual says macros can share an address,but ONLY if one uses the on trigger and one uses an off trigger??

Any suggestions would be greatly appreciated
Thanks
Title: Re: Macros set up
Post by: thejfk on October 07, 2008, 12:49:45 AM
After further review...I  moved the CM15A and now all the macros work...I guess it was an RF issue