X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Vanguard Internet Control Center => Topic started by: Targa on January 26, 2009, 09:16:27 PM
-
Have Vangurad open, and all I get is a bunch of 2" wide lines at the bottom of the vanguard display screen.
Camera is an xcam2
I only have one installed for now.
There is no ability to change the channel on these camera's that I can see.
I have tried all channels on the video reciever with no success on any of them.
Have switched out different cameras to assure it is not the camera.
Have the USB Video input adapter installed as well as the driver.
Camera is 4 feet from the receiver.
All drivers have installed with no visible issues.
Anyone have any ideas ?
-
- ....and all I get is a bunch of 2" wide lines at the bottom of the vanguard display screen.
- There is no ability to change the channel on these camera's that I can see.
On the cameras base... you should see a little rubber oval. If you carefully pry up the oval plug you will see the tiny little channel selector. Maybe try the setup on a TV first. Your doing things the correct way by testing and learning the setup processes before mounting the cameras.