X10 Community Forum

🔌General Home Automation => Original ActiveHome => Topic started by: stamp man on February 04, 2009, 05:43:39 PM

Title: Using BS2 to control CM11A module
Post by: stamp man on February 04, 2009, 05:43:39 PM
I am developing a home monitoring system using a PC and Basic Stamp modules to do the control/monitoring.  I have an old CM11A module that I dug out and it tests ok.  What I am looking for is some sample BASIC code that I can load into the BS2E module to see how it plays.  I also need to understand the hardware interfacing. 

Anyone out there have have experience working with the BS2e and the CM11A module?

Thanks.
Title: Re: Using BS2 to control CM11A module
Post by: Brian H on February 05, 2009, 06:47:50 AM
Have you looked on the Parallax web site for examples. I remember at one time seeing some BS2 stuff with X10. Though that may have been with the TW523 X10 Interface.
Title: Re: Using BS2 to control CM11A module
Post by: stamp man on February 05, 2009, 10:12:57 AM
I just checked and did not see anything.  I will do some more checking.  Seems like a natural fit, using the Stamp with these modules.
Title: Re: Using BS2 to control CM11A module
Post by: Brian H on February 05, 2009, 02:07:59 PM
I have not used my BS2 stuff in awhile.
I believe the PBASIC Manual had one example in it.
I think the rest where from the Nuts and Volts Articles that where downloadable. Though I just checked and didn't see them in the downloads area. When I get home I will see exactly which Nuts and Volts a issues had the X10 stuff in them. Some maybe still in the Nuts and Volts web sites archives.