X10 Community Forum
🎭Entertainment => Entertainment General => iconRemote => Topic started by: drjay77 on April 16, 2009, 11:50:51 PM
-
I received my X10 icon remote today. model # is IR10A. I began setting up my remote and was able to get the TV set up, and my blu ray player partially set up. After tinkering around with a few different codes, I did a master clear to start over. Once I did the master clear, I am no longer able to program any device. The codes that previously worked for the TV and the blu ray player no longer work, and neither do any other codes. I went through the whole deal with trying all 330+ codes too, even the ones not for my brand. No device will program at all now.
I sat on hold to technical support for over an hour and only got to speak to someone for 5 minutes. She did not know the answer and put me back on hold where I was then disconnected. I redialed, but have been on hold for another 3o minutes before I was put through to an answering machine. I am too tired to deal with this. B:(
-
....I sat on hold to technical support for over an hour and only got to speak to someone for 5 minutes. She did not know the answer and put me back on hold where I was then disconnected.
That sucks.
Your never put on hold at the forum. I was a beta tester for the Icon remote... so I have done the master clear myself (a few times). Reloading the Icon seemed like part of the testing.
I'd try removing the batteries (for a few minutes). if that doesn't work... clear it again. It should default (when cleared) the the language selection screen.