X10 Community Forum

📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Vanguard Internet Control Center => Topic started by: jmcdoiwell on May 03, 2009, 10:54:40 PM

Title: Maybe I am making this harder than it needs to be.. Am I understanding this?
Post by: jmcdoiwell on May 03, 2009, 10:54:40 PM
4 - Xcam2 cameras
1 - Video receiver
1 - Transceiver module

 So if I understand this correctly...

 I will setup each camera, for the TRANSCEIVER module ( The white thing with the antenna ) using the remote.
 Once they are setup, and in place.  I will be UNable to view all 4 camera at once.  But instead, the receiver will get only one signal at a time.  The vanguard software will tell the TRANSCEIVER to switch between cameras. 

 Am I understanding this correctly?

 Thanks in advance..

 Joshua
Title: Re: Maybe I am making this harder than it needs to be.. Am I understanding this?
Post by: Knightrider on May 03, 2009, 11:01:02 PM
sounds like you got it to me.  I hope that you forgot to mention that you had the cm19a unit to plug into the computer as well.
Title: Re: Maybe I am making this harder than it needs to be.. Am I understanding this?
Post by: jmcdoiwell on May 03, 2009, 11:05:45 PM
Quote from: Knightrider on May 03, 2009, 11:01:02 PM
sounds like you got it to me.  I hope that you forgot to mention that you had the cm19a unit to plug into the computer as well.

  You mean the receiver?  The little black deal?  Yes it's plugged in VIA usb.

 I am trying to fixed a botched install that someone else performed.  I got to the point that I needed the remote, and it was gone so he ordered a new one.  So when I go back, I just want to make sure that I know what I Am talking about.

 Joshua
Title: Re: Maybe I am making this harder than it needs to be.. Am I understanding this?
Post by: Knightrider on May 04, 2009, 08:31:14 PM
I'm a little out of my element here, but I believe you need the VA11A/VA12A to run the video into the computer, and the CM19A or a CM17A or CM15A to send the RF signal from the computer to the transceiver.  Do you have any of those devices?