X10 Community Forum
🔌General Home Automation => Automating Your House => Troubleshooting Automation Problems => Topic started by: dubge on October 29, 2009, 03:02:59 PM
-
So here is what I have, CM15A,HR12a, a bunch of ws12 dimming rocker switches. AHP
All the switches work fine by them self, I can turn on and off all the switches with the remote as well as dim them, I can turn on and off all the lights with the computer as well as dim them BUT when I run a macro it will turn on the living room lights but nothing else, after a little searching around I found out that AHP is not sending out the macro command for the other switches, just the first one BUT it sends out the command to shut them all off
I have both macros set with 2 sec delays in between each set of lights
Anyway to fix this???
Thanks
-
I figured it out, has to rename the switches to a different type (I think that was it)
-
Glad you found it. The Soft Start switches and lamp modules act differently and X10 recommends calling them a LM14 in their wikj.