X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wired Cameras => Topic started by: retired65 on December 22, 2009, 06:41:15 AM
-
can someone tell me how to hook up 2,or 3 wired cameras to my tv, so that i can view them all at once, or individually..i'm a newbie. thanks .
-
Was the video processor I showed you in the last thread unacceptable or do you need more details on its possible use?
-
brian.. i could use more details on it's use and function, if you don't mind...thank you again
-
The one I pointed out doesn't have a users manual for download so I don't have exact details on it. I believe the cameras from the same manufacturer use BNC connector so adapters would be needed. There are probably other video processors used by others. I hope maybe some one will have more information for you.
Basically you can run the four video signals into the processor and it can cycle though them in sequence or I believe put all four on to one screen divided by four. The output goes to the TV. The audio is not supported and in some areas maybe illegal for sound anyway.
Does the TV have a video input where you have tried one of the cameras now?
Do you want all cameras on and then processed? As they could be turned on and off by the software. Though I believe you had no luck with the software.
I will try and find more details
This site is a generic Automation Site. You may find added information on video processing there also.
http://www.cocoontech.com/forums/
-
thank you brian for your info, that's very kind/......merry christmas
-
You are welcome.
If you have more questions feel free to ask.