X10 Community Forum
🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: sk1pmcgee on January 26, 2010, 03:35:49 PM
-
iF i SET ALL MY MOTION SENSORS TO ONE HOUSE CODE LETS SAY "M" for motion
and all my lights that are gonig to be controlled by those sensros lets say "L" for lights
Do I have to run a macro that says when motion is detected by M1 (motion sensor #1) turn on L1(light #1) or can I just add the modules into AHP and they will work
Thanks in advance
Chris
-
When a module is a different address than the sensor you do need to write a macro for the sensor to trigger and control the module.