X10 Community Forum

💬General Category => General Discussion => Topic started by: john441 on July 01, 2010, 06:03:25 PM

Title: Sentinel Camera not responding to remote
Post by: john441 on July 01, 2010, 06:03:25 PM
All of sudden my Sentinel camera no longer receives commands from the remote.


First it was just the pan and tilt.  Now everything, zoom, focus etc. will not work.

I have it hard wired and the video is fine.

Also, in the past whenever I would disconnect and reconnect the power the supply, the camera would always move back to the center default position.
This no longer happens.

I even took the remote outside, about 10 feet from the camera and it would still not work.

I think the remote is OK.  I plugged in my PSX01 repeater and it does respond from my remote. Fresh batteries were installed too.

I find it hard to believe that all of the motors could go bad at the same time.

Anyone have any idea what the problem might be?


Any help would be greatly appreciated.