X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Vanguard Internet Control Center => Topic started by: coasterdude on July 17, 2010, 11:43:04 AM
-
I have AHP and Vanguard installed on my Windows 7 x64 system. I was surprised it all loaded! AHP is working fine and I can remote in and see videos through vanguard. I have a motion sensor (at A1) setup to to record video (or snaps) for camara A14. No matter what I do it just wont work. It will do the automatic recording as set under SNAPSHOT . I have everything installed in the same room just for a test. I also have a Logitech remote with the RF adapter and that works for all my house etc.. so I know my system is good (or as good as its going to get with no software updates). The version of Vanguard I have is 3.236.
Another question, I have the video set to record as AVI and also 10sec before motion is detected. I see it is caching video with a PVI exention. What do you use to view this?
Anyone have any ideas?
TIA,