X10 Community Forum
🛡Home Security => Problems and Troubleshooting => Topic started by: tybirdtybird on August 02, 2010, 11:41:53 PM
-
DS7000 system and the two remotes Kr10a Sh624 are not controling the lamp modules everything was working great then it stop. The remote will arm and disalarm the system. I tried reset DS7000 reprogram the remote but didn't help. The system only 15 days old. we didn't plug in anything new not one thing change. I tested the lamp modules with mini controler they work fine.
Ty B :( B:( B:( B:(
-
Try turning the House Code and Unit code dials around a few times.
Seems we are seeing dials that are set to one address but are intermittent and the console thinks it is on a different address.
-
That didn't help. now it will not arm just hear the chimes going off. i also tried moving to other outlet didn't help.
-
You could try a complete reset.
Remove battery and unplug from AC.
Wait a few minutes and start from scratch.
If you have not looked at the X10 wiki security console area.
http://kbase.x10.com/wiki/Protector_Plus_Wireless_Voice_Dialer_Security_System
Could also be a ask X10 for a replacemet exchange time.
-
I try that. then i saw somewhere here try power strip. going to try that to.
Thank you Brain for your help
Ty
-
If you put the console on a power strip and it has a power line filter in it.
You will stop all X10 power line signals from reaching the lamp modules; that use the power line to receive signals.
-
The power strip works great