X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: Dan Lawrence on October 26, 2010, 08:27:13 PM
-
I have 2 Soft-Start Lamp Modules and decided to use one on a single lamp which has no problems with a standard Lamp Module. When I replaced the standard module with a Soft-Start one and used the LM14A to control it I created a new .ahx file to handle it. When I uploaded it to the CM15A, AHP would not properly show the module status. I cleared the interface, then closed AHP, put the standard Module back in use and reopened AHP with the standard file uploaded and everything worked properly.
Is this a tiny bug in 3.293?
-
It may not be a bug, but rather, a fix. It could be that the CM15 is waiting for a status report from the LM14A, but as you're using a standard, one-way unit, the report never comes.
My keypad links have a setting that does that. I accidentally programed my KPL for a 2-way device whilst using a standard module. The result is that the KPL will flash as waiting for a status report, and show that the unit is off, as no report is received.
Just a thought.
-
It may not be a bug, but rather, a fix. It could be that the CM15 is waiting for a status report from the LM14A, but as you're using a standard, one-way unit, the report never comes.
My keypad links have a setting that does that. I accidentally programed my KPL for a 2-way device whilst using a standard module. The result is that the KPL will flash as waiting for a status report, and show that the unit is off, as no report is received.
Just a thought.
I was using a Soft-Start LM465 installed in AHP as an LM14A Two-Way Module. After the problem arose with AHP not showing proper status I went back to the Standard LM465 I'd been using and the Fall.ahx file for this time of year. No status problems.
-
perplexing indeed. Can you duplicate the results?
-
Maybe later. I only have 2 SS, but dozens of standard ones, so using SS is kind of back rear burner for me right now.