X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wireless Cameras(non IP) => Topic started by: ricquelle on February 26, 2011, 01:35:26 PM
-
I have a three camera system:
2 XCam 2 Cameras A1 & A2
1 B&W Low Light Camera A3
3 Eagle Eye Motion Detectors
TM751
PC Transceiver
Vanguard and Active Home Pro
Everything was working fine...until today when I replace the 1 B&W Low Light Camera A3 with an XCam2 XX17A. Now in Vanguard when I click on that Camera I cannot get it to stay on that camera for any length of time. It will switch to that camera but within 2 seconds changes back to A2 - it was not doing that when I had the B&W Lowlight Camera.
Any suggestions?