X10 Community Forum
🛡Home Security => Problems and Troubleshooting => Topic started by: DJAYA on July 12, 2011, 11:38:17 AM
-
I am having a problem getting the KR10A to turn on the socket rocket. It works fine using the SC1200 and SH624 and even the telephone. House code is set to C and light code to 2. Any Ideas? Thanks.
-
The KR10A does the second Light Code. So if the SC1200 is set to House Code C and Light Code 2. The KR10A will do C3.
The SH624 does the Light Code the SC1200 is set to if my memory is correct.
You can test this by temporarily setting the SC1200 to Light Code 1 and see if the KR10A then controlls the Socket Rocket on C2. Then the SH624 Security Light buttons may not control it. Though the 1-4 unit code buttons on it should still access the Socket Rocket with its #2 button set.
-
Found my test notes.
SC1200A
Default House Code A and Light Code {Unit Code}1
Lights On then Lights Off Button on remote.
KR10A:
R: A2 - 7:08:54 PM 6/23/2011
R: AOn - 7:08:54 PM 6/23/2011
R: A2 - 7:08:57 PM 6/23/2011
R: AOff - 7:08:57 PM 6/23/2011
KR32A:
R: A2 - 7:09:00 PM 6/23/2011
R: AOn - 7:09:01 PM 6/23/2011
R: A2 - 7:09:02 PM 6/23/2011
R: AOff - 7:09:02 PM 6/23/2011
SH624:
R: A1 - 7:09:05 PM 6/23/2011
R: AOn - 7:09:05 PM 6/23/2011
R: A1 - 7:09:06 PM 6/23/2011
R: AOff - 7:09:07 PM 6/23/2011
-
So if I reprogram the socket rocket on 3 it should work? Thanks again
-
Ok I program the socket rocket on 3 and it works now. Thanks
-
OK just remember. Now the Lights Buttons on the SH624 will not control the C3 Socket Rockets.
-
OK just remember. Now the Lights Buttons on the SH624 will not control the C3 Socket Rockets.
I am fine with that. As an aside when I first setup the SC1200 I had the low battery problem from a few sensors. I followed your suggestion of forcing a new ID and so far so good.