X10 Community Forum
🎭Entertainment => Entertainment General => Nstinct Remote => Topic started by: Gismo on November 01, 2011, 03:51:50 PM
-
How can I get the power button to turn on my TV and my Pace RNG-110 HD cable box from Comcast at the same time?????
-
I recorded a macro for the Power button and learned both the power command for my TV remote and the power command for my FIOS remote.
And about 30 seconds later I realized that my FIOS remote turns both devices on when I press "Power", because when I tested the learning on the IR34A, my TV turned on, the FIOS box turned on and the TV turned off again. Duh.
Then I re-recorded the learned command for the power button just from the FIOS remote, which was already programmed to send both codes.
Then I reset the FIOS remote to only turn on the FIOS receiver and assigned that to a side button, in the event I want to switch from the FIOS box to another device, need to keep the TV on but want to turn the FIOS box off.
See pages 25-35 in your manual for instructions.
Good luck!
-
So your saying that you programmed the remote power button(all lights on button) to turn on TV and Fios by the learning mode?
-
I used the main power button. I only did that for FIOS mode, so if I put the remote into TV mode I will only turn the TV on / off by using the main power button.