X10 Community Forum

💬General Category => General Discussion => X10 Product Wish List => Topic started by: tploy on August 01, 2012, 06:18:32 PM

Title: Active Home AirSight Interface
Post by: tploy on August 01, 2012, 06:18:32 PM
I recently purchased the new Airsight IP Outdoor Cameras and the Active Home Software package to control the Ninja Camera Base Interface to remotely position the Outdoor Cameras. It took a while to get everything set up and working But I've managed to get one of three units working as I want it to (the one closest to the transmiter attached to the computer). By using the Airsight Software to monitor the camera view and the active Home Iwatchout software to move the Ninja camera base.

However What I WISH for is to have the Iwatchout software be able to display the IP Video Feed From the Airsight Cameras It currently only will interface with the proprietary USB X10 Camera interface.

Also, I WISH that the signal from the Active Home Software Interface (CM19A) could be addressed to signal relay through the X10 Modules EX use one module as a signal receiver (RR501) and repeating it from another module (TM751) to transmit to another Ninja Base (VK74A) at a distance of around 550 ft (Maximum distance) Since I have cameras positioned covering more than an acre of land and can place additional Repeater modules near the Ninja units.
Title: Re: Active Home AirSight Interface
Post by: Dan Lawrence on August 01, 2012, 07:50:08 PM
The CM19A has nothing like the CM15A did.   It needs a TM751 or a RR501 to put signals on the powerlline.