X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: medic5678 on October 14, 2012, 01:30:58 PM
-
???
if not, then what would it work with? thanks!
-
I have never seen AHP MR26A support mentioned in any threads.
The only serial port device I have seen AHP supported was the CM11A.
Here is the original MR26A page showing what it did work with when originally sold.
http://www.x10.com/products/x10_mr26a.htm
I have not seen a list of other vendors software that support the MR26A but I know they do exist.
Fellow users here may have added data for you.
-
I haven't tested mine with the AHP SDK.
The x10 Firecracker software might work
It has been a while since I used one as the Cm19a took it's place.
There are lots of thirdparty software available in the thirdparty and addon section most are free or have a trial period which will allow you to test
>!
-
for what it's worth, i picked up three of them from x10's dollar store. for 3 bucks, maybe there's a use for them .... if not just parts for other projects :). i have fired up my soldering iron!