X10 Community Forum
📸Cameras & Camera Software => AirSight Cameras => Topic started by: edkaygray on July 29, 2014, 10:56:44 PM
-
Have had airsight x10 cameras for a long time and they were working fine. Our wireless modem went out, got new modem wireless etch and now can't get them to work. I do the set up as instructed click on the active x mode, can view live picture but when click on network to get to wireless setting it says wait still loading and won't ever go to the wireless set up. Need these cameras to work wireless. Any suggestions would be great. thanks
-
Did you reset the camera to factory settings before attempting to do a setup?
It may be trying to use old settings and that could be causing the hang up.
-
I don't think I reset it. I just disconnected it from the electric source and rehooked it back to the wireless modem, redid the ip cam set up, it found the camera and I get picture but when I click on network to get to the wireless settings it says busy now try again later and then shows the basic network but will not go to the wireless setup area
-
I hit the reset button on the camera and then went thru the set up again. It does fine until I get to the IP cam viewer, get live picture but when I hit the network button to be able to select the wireless section, it comes up with message loading, try again later; then goes to basic network and won't do anything else. Any further advice.
-
You didn't indicate what model you have but I did find some information.
Are you using a wired connection to set up the wireless features?
http://kbase.x10.com/wiki/IP_Camera_Wireless_Setup