X10 Community Forum
🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: bt54 on February 04, 2016, 04:26:11 PM
-
I have a macro that is activated when a WS267 is activated. When I manually turn on the WS267 the signal is NOT displayed in the activity monitor. From AHP I can turn on the light, the macro fires and the light turns off after the macro assigned time.
C3 - WS267 Address
Macro Trigger C3 ON
Wait 5 Minutes
C3 - Off
-
Do you mean a WS467 switch?
This switch doesn't send a x10 signal it only has a reciever built in.
-
You are correct it is a WS467. I swapped WS467's and the macro finally worked. Does that sound right since it does not have a transmitter??
-
If it was a X10 WS467 it has no power line transmitter in it. So it should not trigger your macro.
You don't have any X10 device that can send a signal like a Motion Sensor?
The second one was not a Smarthome Model X10WS467D was it. That was an Insteon Togglelinc with the Insteon labels taken off and you programmed it with an X10 address. That one is a two way device and would send an X10 power line signal back on the power lines from a local activation.
-
Brian,
It is a Powerhouse WS467. I have a test bed with a light and a terminal for connecting switches. The third switch I tried activated the macro twice in a row. I'm installing it in a closet as the better half never turns the light off. If it does not work I'll add a motion detector to the setup.
thanks,
Brian