X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: LostDog88 on October 04, 2018, 12:34:04 PM

Title: Using different House Codes
Post by: LostDog88 on October 04, 2018, 12:34:04 PM: Can I have remotes with different house codes?

Do I need a txmitter? Everythhing works on A. I can see the switches flip in AHP on B. But nothing gets transmitted.

I am presuming I need a transmitter of some sort? I take it the CM15A won't do this?

Thanks,
Title: Re: Using different House Codes
Post by: Tuicemen on October 04, 2018, 01:38:22 PM: The Cm15 will do this it is a transceiver but you have to specify what house codes to transceiver under tools select hardware configuration then in the bottom right select the house codes you wish transceived and check the specific check box not the auto then update interface.
Title: Re: Using different House Codes
Post by: LostDog88 on October 04, 2018, 01:52:24 PM: Thank you. Worked like a champ!
Title: Re: Using different House Codes
Post by: LostDog88 on October 23, 2018, 11:55:51 PM: But wait, wait, wait.

The HG software notices that the switch (module) in Home Genie goes to off....there has to be some fancy code you can write that monitors this situation and responds to the trigger???

Right????
Title: Re: Using different House Codes
Post by: Tuicemen on October 24, 2018, 08:59:08 AM: Quote from: LostDog88 on October 23, 2018, 11:55:51 PM
But wait, wait, wait.

The HG software notices that the switch (module) in Home Genie goes to off....there has to be some fancy code you can write that monitors this situation and responds to the trigger???

Right????
Yes! There is the AHP SDK which only works in Windows machines or there is the USBLIB driver which HG and Mochad use.
Several Home Automation software options use Mochad to interface with X10.
Title: Re: Using different House Codes
Post by: petera on October 24, 2018, 02:48:38 PM: Quote from: LostDog88 on October 23, 2018, 11:55:51 PM
But wait, wait, wait.

The HG software notices that the switch (module) in Home Genie goes to off....there has to be some fancy code you can write that monitors this situation and responds to the trigger???

Right????

What are you using. AHP or Homegenie.
Title: Re: Using different House Codes
Post by: LostDog88 on October 24, 2018, 11:41:06 PM: At that time I was using AHP......not sure what I was smoking/drinking when I stated Home Genie! LOL........

Anywho, now I am running Home Genie. I found that the limitations of windows and AHP were too much for me to overcome. So..........Linux was the next best answer.

I tried Domoticz....I wanted it bad. But after three and a half hours I couldn't get it to work. So....I installed HG. It is working great and I love, love, love it!!