X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: omar on April 13, 2005, 02:30:52 PM
-
Hello, recently I unplugged my cm15a from
my computer and let it stand alone and
about 10 minutes after, some of my lights
turned on...note that i do not have any
timers setup on my system yet...what could
be going wrong?
-
That's odd. So CM15A detached from
computer's USB and plugged in an electrical
outlet then 10 minutes after some lights are
turning on. Were you able to reproduce this
behavior?
-
Has this happened again? Do you have remote
controls or motion sensors that might have
been in use?
-
Yes, it happened a few weeks ago too when i
had a power glitch at home and my computer
turned off...batteries in the cm15a seem to
be working fine
-
No, there were no remote controls being
used and i have no motion sensors...and not
all the lights turned on, just a few
-
The lights that turned on, were they defined
(referenced)within any macros?
-
No, they are not in any macro
-
What module addresses are being used?
-
a3 thru a8...although not all of them
turned on
-
If you connect the interface to the PC, clear
the memory, then disconnect it, what happens?
-
Could one of your neighbors be using x10 on
the same house code?