X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: valpin on April 26, 2005, 10:25:58 AM
-
How can I do a full system reset on my CM15A
and AHP software? I have too many bugs and I
would like to restart fresh with one module
at the time.
-
If you want to start fresh, clear the
interface memory, then create a new, blank
file. Add one module, set the hardware
settings as appropriate and then download
again. After that you can add modules
gradually, and see how things develop.
-
Go to tools and click on purge delayed macros just in case one is running
then click on clear interface memory under tools
as well shut down AHP and remove the CM15a from the power and usb cable
remove the batteries then
after 5-10 min replace everything
restart AHP and click on file then new that will start you fresh.
You can then save your new AHP file over an old one or save it as something else. Older software versions had some bugs that may cause you some headaches starting fresh but no more than you currently experiencing.