X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: joe on December 08, 2005, 01:35:32 PM
-
Posted this on the iWitness forum but got no
response so here goes:
I have a nice PZT dome camera that has an
RS-485 pelco P/D interface and I was
wondering if the iWitness SW can control it.
I think the way it would be set up is the
video goes into the capture module and then
the serial port uses an RS-485 converter to
talk to the tilt and pan part. The camera
head is a Sony using the Visca protocol.
Thanks,
Joe