X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: donald mcmow on March 23, 2005, 10:07:20 AM
-
I noticed that there seams to be a problem
when macros are triggered. While using
Smartmacro with an "ELSE" statement creates
2 macros ie: 2 macros on the same address
code - A1 On. A 3rd macro is created on A1
Off. I noticed that when macro #1 is
triggered the buttons on ALL 3 macros are
flashing. The command sequence is small -
check a flag, if Off then turn on a light,
If On then turn the flag off. Macro #3
turns the flag On. It seams to work for a
couple of times and then you can't run the
macro and have the commands execute
properly, after that it stops working.