X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: nswint on May 08, 2005, 01:51:36 AM
-
1. I'm unable to select modules outside of A1
- A16 in the Macro Designer.
For example in the Macro Designer - Condition
Wizard - When a certain module is on - No
modules outside of A1-A16 are available.
2. New Macros Default to Ax+1. Where X is
the last unit code created under A.
3. New Macros Default to the first created
room. Instead of the room you are currently in
-
1. The module status condition checks the
status of modules in the Monitored House Code
only, so if you have the Monitored House Code
set to A, only A shows up there.
2. Any new module defaults to the next
available unit in the most used House Code,
so I think this is as designed.
3. This bugs me too. I'll make sure it's on
our list to fix.