X10 Community Forum

📸Cameras & Camera Software => Camera General Discussion => Topic started by: brian on February 19, 2005, 03:15:03 PM

Title: VCR Commander
Post by: brian on February 19, 2005, 03:15:03 PM

Hi, I must be doing something wrong. I
followed  the instructions for set-up, but
the LEDS do not seem to be functioning in a
fashion the manual says they should. It tells
me that the LED on the vcr commander should
blink every second or so depending on its
current operational status, but I see no LEDS
in use at all, unless I trip the sensor in
which the LED will blink at that time, but
the VCR will not come on. Any help is much
appreciated. Thanks in advance.

Title: Re: VCR Commander
Post by: zap on February 26, 2005, 12:01:04 PM

i had the same trouble....  seems like your
commander didnt learn your remote codes. you
might have to hold the remote really close to
the pickup on the commander to get it to read
the signal.  

Title: Re: VCR Commander
Post by: john on March 10, 2005, 12:50:47 AM

hey brian i have the same problem how was
this retified. john

Title: Re: VCR Commander
Post by: j on March 10, 2005, 12:49:41 PM

also try all three tabs coming from the
commander and stick them close to the sensor
on the vcr. i have one vcr that will work
with only one tab but the onther will not
work unless they are all stuck on the dam
thing

Title: Re: VCR Commander
Post by: mark on March 12, 2005, 04:31:51 AM

Hi i am from holland and using alot x 10
stuf and had problems with the vcr2 also
but afte putting the commands in the vcr2
after 3 days testing lol i yust did play
with the away and home mode and walah it
works perfect as long the vcr2 beeps you do
something wrong