X10 Community Forum
📸Cameras & Camera Software => Camera General Discussion => Topic started by: edward s. on April 19, 2005, 12:43:49 AM
-
Hey all, recently my Ninja Pan'n'Tilt has
been moving very "jumpy" when I manually
move it. When I hit the scan button it
moves very smoothly, just not when I go
manual on it. It didn't use to do this, I
unplugged it to move a few things around
and then when I pluged it back in it was
all weird. I've tried unplugging it again
and the same results. Also I can't switch
seemlessly between cameras in AHP, I have
to use the rf controller. Any ideas on
both of these issues? Thanks all!!