X10 Community Forum
📸Cameras & Camera Software => Camera General Discussion => Topic started by: bart on December 17, 2005, 04:58:39 PM
-
I previously had a wireless camera setup
using MultiView, and everything worked just
fine. I had to disassemble all of my X10
stuff (cams, automation) in order to do some
extensive home remodeling. Since the
remodel, I have installed Linksys Wi-Fi, but
the cams have not yet been hooked back up. I
have just recently purchased AHP with
iWitness and MyHouse software.
I have been reading the boards and see that
some people have been having problems with
wireless cameras and WiFi. Since my cameras
are not yet setup, I don't know if I will be
having these types of problems with my WiFi.
I was wondering, if I do have these types of
problems and cannot get them corrected my
switching channels on the cams and/or WiFi,
would it be possible to get Anaconda wired
cams and use them in my system, all the
while still being able to use iWitness and
MyHouse? Obviously, I would need a different
type of receiver by the PC for the wired
cams to connect to, and then going from this
receiver into the PC. But I was just
wondering if iWitness and MyHouse were
specifically for use with the wireless cams
only.