X10 Community Forum
📸Cameras & Camera Software => Camera General Discussion => Topic started by: tim on January 27, 2006, 01:01:18 PM
-
Hi folks. I can't get the CR12A to scan
(press the blue button) beyond the first
group (1-4). I follow the manual, press the
5 on (Hold) and slide the switch (1-8,9-16)
back and forward. Nothing happen. It won't
scan the group 2 or for that matter I try
group 3 and 4 (I have 14 cameras) and it
doesn't work. I have a CR14a (pan'n tilt
remote) and it works just fine. Is there a
special way to program the CR12A? I check
the batttery, use different CR12A but
nothing work. Please help. Thanks.
-
I belive it only does one group of 4. If you
have more the cr13a can be programed to do
more than 4 cameras.
-
Thanks for the reply. My problem is that
all of my CR12A will not be programmed. In
other word, it always stuck on group 1
(camera 1 - 4). I read the instruction and
follow it so many times, it just won't
change to other group. I was wondering if
anyone has success in changing the group
with this remote. Is there other step
(other than mention in that instruction
sheet) that I miss? Thanks.
-
Oh I understand your problem now. Will do
some digging and see if I can find anything
out.