X10 Community Forum

🛡Home Security => Home Security General => Topic started by: debbie on July 09, 2004, 01:16:01 AM

Title: Clear/Cancel a zone?
Post by: debbie on July 09, 2004, 01:16:01 AM

I managed to set my motion detector on two
different zones, the first zone I set it on
is now solid red and I have to bypass it to
arm the system.  Is there a way to
clear/cancel a zone?

Title: Re: Clear/Cancel a zone?
Post by: DanGI on July 13, 2004, 08:26:06 PM

The only way is to clear the entire
configuration and then re-register one by
one each of your sensor.  To clear the
configuration you will need to disconnect
the unit from the power outlet AND remove
the battery for few seconds.