X10 Community Forum
🔌General Home Automation => Automating Your House => Topic started by: tyler on November 07, 2005, 12:40:33 AM
-
I have a lamp module that likes to decide to
work or not. I have it on A-15 and the other
devices in the room are set to A-3 and other
lower numbers. I have tried letting the
device sit unplugged, I tried rotating the
dials to try to see if that would reset it
but I am not getting anywhere. What is the
cause of the problem? activehomepro will not
recognize it. I flip the switch and it
doesnt respond.
-Tyler
-
lyonrt: The most probible cause is poor
phase coupling. I wrote a tutorial on
phase coupling at:
http://www.x10.webhop.org/Phase_Coupling.htm