X10 Community Forum
🔌General Home Automation => Automating Your House => Topic started by: ranger ric on November 20, 2005, 12:42:02 AM
-
I would like to use an x10 system to control my water
water recirculating pump. The pump itself is a very
small Grunfos so the rating of the switch does not
have to be large. The idea is to have the pump come on
for a set amount of time (for example 2-3 minutes)
whenever a switch is activated in the bathroom. So I need
some kind of a switch that urns itself off after a short time
and can be controlled by an x10 transmitter. Any ideas? I
wonder if there is some way to use the timer that comes
inside a motion detector outside light?
-
Buy an X10 CM15A and Active Home Pro
software. You can set timers for any length.
You can download the manual from X10.com
under the Support tab.