X10 Community Forum

🔌General Home Automation => Automating Your House => Topic started by: TomSki on December 21, 2005, 08:31:51 PM

Title: How to "flash" lights
Post by: TomSki on December 21, 2005, 08:31:51 PM

I have an operational MS-16A with associated
macros working, however, I would like to also
make two additional security lamps flash on
and off when motion is detected. Any
suggestions about how to do this using the
X-10 software?

Thanks,
Tom

Title: Re: How to "flash" lights
Post by: stephane on December 30, 2005, 01:22:55 PM

Have you tried putting "delays" of 1 second
in your macro?
On, delay 1 sec, off, delay 1 sec...