X10 Community Forum
🔌General Home Automation => Automating Your House => Topic started by: ptc on January 15, 2006, 01:03:21 AM
-
Does anyone know of a different chime module
that is X10 addressable? I am using the one
that X10 ships with a motion sensor that
works great as a driveway sensor. I would
just like a nicer sounding chime.
-
I prefer the UM506 Universal Module, which
just sounds a beep-beep-beep-beep, plus it's
a little louder than the Chime Module. Or
you could use the momentary contact closure
on the UM506 to trigger whatever doorbell
chime suits your fancy.
-
Thanks for the suggestion. I will give it a
try.
As a follow-up question....
I want to build in a delay for the chime so
that when motion is detected the chime is
activated and then the chime would not
activate again for a period of time, like 5
minutes. This would avoid multiple chimes
as people walk in front of the sensor
multiple times. It is a similar idea to the
delay in sending an 'off' command. I think
that I may be able to program it using smart
macros, do you have any ideas?
-
A Smart Macro seems to be a good way to go. To enable/disable the chime sound, you can use the programmable delay between On and Off signals available in the MS13A/MS14A/MS15A/MS16A motion detectors. The MS12A has a fixed 6 minute delay but there's a hardware mod to change it at: http://www.idobartana.com/hakb/index.htm (http://www.idobartana.com/hakb/index.htm)