X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wireless Cameras(non IP) => Topic started by: NUTEXPHX on February 24, 2006, 04:10:31 PM
-
I have a simple 10 wireless camera and a wireless receiver that is for that unit and one that came with my pan tilt ninja cameras. I have always hooked all my cams up where they are received thru the wireless recv; then coxiaxed and RCA jacked from there to a VCR recorder player and then to the TV. I even have a splitter on the coax to view cable if I get tired of viewing cam views. Now I can't get a view in the TV if the camera, I've troubleshot everything and everyway I know. what is the prob. Can someone help? Desperately seeking view :'( ??? >:( :-[ :-\ :'(
-
It could be a couple of things
1: make sure your cams are on the same house code but diff numbers
2: cam recievers handle cams in groups of 4 eg1-4 5-8 ect so keep them in the same group
3: The reciever has 4 channels make sure it is the same as the cams
4: This one is silly but I've done it! ::) Make sure the reciever is on (red light bottom front should be on)
-
Are you adding a 2nd camera now? I would almost say it has to do with the splitter or 2nd cam not set to the correct frequency, a rubber cover contains the frequency switch, These should match. maybe a single reciever instead of 2 seperate ones?
you said here I even have a splitter on the coax to view cable if I get tired of viewing cam views. Now I can't get a view in the TV if the camera
Id need more specific info on exactly how you have this setup, and more info on what this sentence says... if the camera what? :)