X10 Community Forum
🔌General Home Automation => Original ActiveHome => Topic started by: bravoland on May 05, 2006, 05:37:02 PM
-
I have been using X10 for a good 2 years now and me and my wife are very pleased with it. my question is.. i usually setup timers for light or appliance modules and i always check the store in interface Button. I was under the impression that by storing in the cm11 that i wanted to turn on the light in the living room at 11 tonight that even if i shut down the computer after i store the request in the interface that it would go ahead and send the command. but this is not the case.. when i shut off the computer none of the timer's work.. am i doing something wrong, misinformed or possible defective cm11??
-
In addition to checking the box in each timer for "Download to interface", you have to download the whole schedule to the interface by clicking on the menu item Tools > Download Timers and Macros. (And then make sure the CM11A clock is set to the right time.)
-
that was to easy!
thank you!