X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wireless Cameras(non IP) => Topic started by: kevinrea on May 31, 2006, 02:40:18 PM
-
hi guys,
i am using the TM751 transceiver and the vr31a receiver with 3 wireless cameras and a CR13a remote.
is there anyway to automatically have the cameras scan on my monitor/tv without pressing the buttons one after the other?
that is, it starts with one camera, stays on it a few seconds, and then goes to the next and so on.
and, is there anyway to change the frequency of time spent on one camera before it changes to the next ?
thanks,
kevin rea
kevinrea@adelphia.net