Please login or register.

Login with username, password and session length

Author Topic: Using On Alert and Security system  (Read 11465 times)

sjx10

  • Newbie
  • Helpful Post Rating: 0
  • Posts: 4
Using On Alert and Security system
« on: January 19, 2007, 09:22:13 AM »

I have recently purchased the full home automation set of software and the full PS561 security system.  However, I am not sure how to make the OnAlert system manage devices (when each one needs a unique address) and the security system needs all the devices to be on the same address.

How do I do this - am I just confused?

Steve
Logged

Puck

  • Advanced Member
  • Hero Member
  • ******
  • Helpful Post Rating: 171
  • Posts: 1799
Re: Using On Alert and Security system
« Reply #1 on: January 19, 2007, 09:36:22 AM »

...(when each one needs a unique address) and the security system needs all the devices to be on the same address.

In OnAlert, yes each security device (Door/Window Sensor, Motion Detector, Remote) does require a separate House Code / Unit Code Address. But on the PS561, this does not apply... you just register them with the console via the install mode. The House Code on the PS561 is just for the security lights & sirens that you want to flash & sound.

Read through the posts that Tuicemen references here: Tips and Helpfull Suggestions!

Also read through this post for some helpful information on setting up the sensors addresses on OnAlert: Some observations
Logged
 

X10.com | About X10 | X10 Security Systems | Cameras| Package Deals
© Copyright 2014-2016 X10.com All rights reserved.